COMPONENTS
![](new-img/acsourceuse.png)
AC Source
![](new-img/thyristor.png)
Thyristor
![](new-img/pulse.png)
Gate Pulse
![](new-img/resistor.png)
Resistor
![](new-img/inductor.png)
Inductor
![](new-img/vmeter.png)
Voltmeter
![](new-img/ammeter2.png)
Ammeter
![](new-img/ground.png)
Ground
OBSERVATION TABLE
S.No. | VLrms (V) |
ILrms (A) |
VLavg (V) |
ILavg (A) |
---|---|---|---|---|
IL
17
18
VT1
5
6
9
7
8
T1
10
GP1
VT3
11
12
T3
15
13
14
16
GP3
VGP1
19
20
21
GND1
37
38
R
VINP
1
2
3
4
AC
41
42
VLOAD
VGP4
34
35
36
GND2
39
40
L
VT4
22
23
T4
26
24
25
GP4
27
VT2
28
29
T2
32
30
31
GP2
33
WAVEFORM
- STEP 1: Drag and drop the components in the workspace to create the circuit.
- Nos of required components:
- AC Source – 1, Thyristor – 4, Gate Pulse – 4, Resistor - 1
- Inductor - 1, Ammeter – 1, Voltmeter – 8, Ground - 2
- STEP 2: Make the connections as per the instructions given below:
- (a) (01-03, 03-08, 02-04, 08-24, 14-30)
- (b) (04-30, 05-07, 06-08, 07-17, 13-17)
- (c) (18-37, 09-10, 11-13, 12-14, 15-16)
- (d) (10-19, 20-21, 22-24, 23-25, 26-27)
- (e) (27-35, 34-36, 28-30, 29-31, 32-33)
- (f) (25-31, 31-40, 38-39, 37-41, 40-42)
- STEP 3: Click on the CHECK button to check the connections.
- Note: Right click on the component to open the dialog box to edit the properties of the component.
- STEP 4: Input the values for all the required components (AC Source, Gate Pulses, Resistor and Inductor) and the waveform will get plot automatically.
- STEP 5: Now, Click on the ADD button to insert the reading into the observation table.
- STEP 6: Now, you can input different values as per your requirement to get the desired waveform.
- STEP 7: Repeat Step 5 to again insert the reading into the table and now repeat Steps 6 to 7 to take more readings.
- STEP 8: Click on the PRINT button to take out the print of the webpage.
- STEP 9: Click on the RESET button to reload the webpage.